Security Sensor

Description: The Security Sensor is a magnetic on/off switch which is used as an input to the sensorProbe. Security Sensors come in pairs. They are active switches that close when one half of the sensor is in close proximity to its mate. When the two sensor pairs are moved apart from each other they open. The sensorProbe senses closure and opening and reports the condition.

The Security Sensor plugs into any of our intelligent SensorProbes, such as the SensorProbe2, the SensorProbe8, or any SecurityProbe.

Security Sensors can be wired in series so that multiple sensors can use a single port on the sensorProbe. There are no reasonable limits on the distance of the security sensors from the sensorProbe. Security sensor with an ALARM/NORMAL indication in software. Can have an unlimited number of security sensors. Security sensors can detect doors, windows. SNMP interface for alarm/normal status. SNMP traps sent when critical. SNMP polling via get available. Web browser interface available. When an alarm condition is activated the description and location of the fault can be sent via email, page.

Specifications & Features:

Measurement range - Alarm or Normal

Communications cable - RJ45 jack to sensor using UTP Cat 5 wire,

Maximum extension cable length 305m (1000 ft.) with approved low capacitance shielded cable or UTP.

Sensor type - open/closed contact switch

Power source: powered by the sensorProbe. No additional power needed

sensorProbe autodetects the presence of the security sensor

Measurement rate - multiple readings every second

Up to 2 security sensors per sensorProbe2, 8 per sensorProbe8 and cameraProeb8

Full autosense including disconnect alarm